fbpx

APC BX950UI BACK-UPS 950VA, 230V,

919.00

In stock

  • Output power capacity: 480Watts / 950VA
  • Output Connections: (1) IEC Jumpers (Battery Backup) (6) IEC 320 C13 (Battery Backup)
  • Nominal Output Voltage: 230V
  • Nominal Input Voltage: 230V
  • Input Connections: IEC-320 C14
  • Cord Length: 1.22meters
  • Maximum Input Current: 4.0A
Compare
Category:

Product Description

Automatic restart of loads after UPS shutdown
Automatically starts up the connected equipment upon the return of utility power.

Automatic self-test
A periodic battery self-test ensures early detection of a battery that needs to be replaced.

Automatic Voltage Regulation (AVR)
Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.

Resettable circuit breaker
Easy recovery from overloads; no need to replace a fuse. (Not available on Wall Tap SKUs)

Telephone data line surge protection
Provides protection of connected equipment from power surges traveling on telephone lines.

USB connection
Use your PC to access additional power protection and management features for your UPS via a USB Port.

Back-UPS Features & Benefits
Safety-agency approved
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

Battery-protected and surge-only outlets
Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment

Availability
Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance

Intelligent battery management
Maximizes battery performance, life, and reliability through intelligent, precision charging.

Automatic self-test
A periodic battery self-test ensures early detection of a battery that needs to be replaced.

Manageability
Audible alarms
Provides notification of changing utility power and UPS power conditions

LED status display
Quickly understand unit and power status with visual indicators.

Protection
Surge only outlets
Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.

Battery and surge-protected outlets
Back up and protect your hardware and data during power outages, surges, and spikes.

TECHNICAL SPECIFICATIONS
Output
Max Configurable Power (Watts): 480Watts / 950VA
Output Frequency (sync to mains): 50/60 Hz +/-1 Hz
Output Frequency (not synced): 50/60 Hz +/-1 Hz
Topology: Line Interactive
Waveform type: Stepped approximation to a sinewave
Transfer Time: 8ms typical: 10 ms maximum

Input
Input frequency: 50/60 Hz +/- 3 Hz (auto sensing)
Input voltage range for main operations: 150 – 280 V
Number of Power Cords: 1

Batteries & Runtime
Battery type: Maintenance-free sealed Lead-Acid battery with suspended electrolyte: leakproof
Included Battery Modules: 1
Typical recharge time: 8hour(s)
Expected Battery Life (years): 2 – 5
Battery Volt-Amp-Hour Capacity: 76
Communications & Management
Interface Port(s): USB
Control panel: LED status display with On Line: On Battery: Replace Battery and Overload indicators
Audible Alarm: Alarm when on battery: distinctive low battery alarm: overload continuous tone alarm

Surge Protection and Filtering
Surge energy rating: 273Joules
Data Line Protection: RJ-11 Modem/Fax protection

Environmental
Operating Temperature: 0 – 40 °C
Operating Relative Humidity: 0 – 95 (non-condensing) %
Operating Elevation: 0-3000meters
Storage Temperature: -15 – 45 °C
Storage Relative Humidity: 0 – 95 (non-condensing) %
Storage Elevation: 0-9000meters
Audible noise at 1 meter from surface of unit: 45.0dBA

Be the first to review “APC BX950UI BACK-UPS 950VA, 230V,”

Your email address will not be published. Required fields are marked *

Reviews

There are no reviews yet.

Vendor Information

Main Menu